Transmission Fluid Checking Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

Fig 1: Transaxle Oil Level/Filler Plug

Courtesy of GENERAL MOTORS CORP.

Remove the transaxle oil level/filler plug (2) from the transaxle.
Inspect the transaxle oil level.
Ensure that the oil level is even with the bottom of the transaxle oil level/filler plug hole.
If the oil level is low, adjust the oil level accordingly by adding Type gear oil GL-4 or GL-5, SAE 75W-90 or the equivalent.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the transaxle oil level/filler plug into the transaxle after applying GM P/N 12346004 (Canadian P/N 10953480) or the equivalent, in order to plug the threads.
Tighten: Tighten the transaxle oil level/filler plug to 39 N.m (29 lb ft).
Lower the vehicle.