Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the front transaxle bracket and bolts.
Tighten: Tighten the transaxle bracket bolts to 64 N.m (47 lb ft).
Install the insulator to the mount bracket.
Install the front transaxle mount through bolt.
Tighten: Tighten the transaxle mount through bolt to 52 N.m (38 lb ft).
Install the 2 bolts to the front transaxle mount.
Tighten: Tighten the front transaxle mount bolts to 64 N.m (47 lb ft).
Install the left hand and right hand splash shields.
Lower the vehicle.
Remove the engine support fixture.