LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1329 (Manual Transmission - MTN - Introduction) >> Repair Instructions >> Shift Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the lever knob and the boot.
  3. Remove the front and the rear center console halves.
  4. Remove the center air duct.
  5. Remove the shift cable retainer and the end clips at the control assembly.
  6. Remove the shift cable hold down bracket.
  7. Remove the 4 shift control mounting bolts.
  8. Remove the control assembly.
  9. Remove the shift cable retainers at the transaxle.
  10. Remove the shift cables by pulling them through the inside of the vehicle.