LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1329 (Manual Transmission - MTN - Introduction) >> Diagnostic Information and Procedures >> Fluid Leak Diagnosis and Repair >> Dye and Black Light Method

Dye and Black Light Method

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Add 30 ml (1 oz) of J 28431-6  into the transaxle oil lever/filler plug (10).
  3. Lower the vehicle.
  4. Drive the vehicle for 24 km (15 mi) or until normal operating temperatures are reached.
  5. Turn the ignition switch to the OFF position.
  6. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  7. Use the J 28428-E  in order to locate the source of the leak.
  8. Perform the necessary repairs.