LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1328 (Manual Transmission - MK5 - Introduction) >> Repair Instructions >> Shift Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the gearshift selector assembly. Refer to Gearshift Selector Assembly Replacement .
  3. Remove the inflatable restraint sensing and diagnostic module from the instrument panel. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement in SIR.
    4. Fig 1: Shift Cable Retaining Clips
    GM818634Courtesy of GENERAL MOTORS CORP.
  4. Remove the clips (1), then the washers from the shift cables.
  5. Disconnect the shift cable ends from the transaxle.
  6. Remove the shift cable retaining clips (2), then disconnect the cables from the bracket.
    7. Fig 2: Remove Shift Cable Clamp Retaining Nuts
    GM846695Courtesy of GENERAL MOTORS CORP.
  7. Remove the 2 shift cable clamp retaining nuts.
  8. Remove the clamp from the shift cables.
    9. Fig 3: Remove Shift Cable Grommet Retaining Bolts
    GM846696Courtesy of GENERAL MOTORS CORP.
  9. Remove the 2 shift cable grommet retaining bolts.
  10. Remove the shift cables from the vehicle.
scientia non olet · About LEMON Manuals