LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1328 (Manual Transmission - MK5 - Introduction) >> Repair Instructions >> Gearshift Lever Case Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Element Replacement in Engine Electrical.
  2. Disconnect the shift cables from the transaxle assembly. Refer to Shift Cable Replacement .
  3. Disconnect the backup lamp switch connector from the switch.
    4. Fig 1: Lever Retaining Bolts
    GM847689Courtesy of GENERAL MOTORS CORP.
  4. Remove the backup lamp switch from the transaxle.
    5. Fig 2: Shift Control Support Bracket Bolts
    GM847690Courtesy of GENERAL MOTORS CORP.
  5. Remove the 3 bolts and the shift control support bracket from the transaxle.
    6. Fig 3: Shift Control Lever Bushing
    GM847692Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When removing the shift control lever notice that there is a shift control lever bushing and that it must be replaced in its original position, or incorrect shifting may occur.
  6. Remove the 2 bolts and the control shift lever from the transaxle
  7. Remove the shift control lever bushing from the transaxle.
    8. Fig 4: Lock Ball Assembly
    GM847693Courtesy of GENERAL MOTORS CORP.
  8. Remove the lock ball assembly from the transaxle.
    9. Fig 5: Gear Case Lever Bolts
    GM847694Courtesy of GENERAL MOTORS CORP.
  9. Remove the 4 gear case lever bolts.
  10. Remove the gear case lever assembly from the transaxle.
  11. Remove the gasket.
scientia non olet · About LEMON Manuals