LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1328 (Manual Transmission - MK5 - Introduction) >> Repair Instructions >> Axle Shaft Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Place a drain pan or a suitable container under the transaxle.
    3. Fig 1: Transaxle Oil Level/Filler Plug And Drain Plug
    GM244162Courtesy of GENERAL MOTORS CORP.
  3. Remove the transaxle oil level/filler plug (1) from the transaxle.
  4. Remove the transaxle drain plug (2) from the transaxle.
  5. Drain the transaxle oil.
  6. Remove the wheel drive shaft from the vehicle. Refer to Wheel Drive Shaft Replacement - Front in Wheel Drive Shafts.
  7. Remove the drive axle shaft oil seal from the transaxle.
scientia non olet · About LEMON Manuals