LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Automatic Transmission - Mu4 (Introduction, Service & Replacement)) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative (-) battery cable.
    2. Fig 1: Retaining Bolt And Vehicle Speed Sensor
    GM428221Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the vehicle speed sensor (VSS) electrical connector.
  3. Remove the 1 retaining bolt (1) and the VSS (2) from the transaxle.
  4. Inspect the VSS O-ring for cuts or damage. Replace as necessary.
scientia non olet · About LEMON Manuals