LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Automatic Transmission - Mu4 (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Cooler Pipes and Hoses Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a drain pan or suitable container under the transaxle fluid cooler.
  2. Remove the following from the fluid cooler inlet and the outlet:
    1. The 1 clamp and the fluid cooler inlet hose
    2. The 1 clamp and the fluid cooler outlet hose
  3. Remove the following from the transaxle inlet and the outlet pipes:
    1. The 1 clamp and the fluid cooler inlet hose
    2. The 1 clamp and the fluid cooler outlet hose
    4. Fig 1: Bolt And Fluid Cooler Pipe Bracket
    GM863263Courtesy of GENERAL MOTORS CORP.
  4. Remove the 1 bolt and the fluid cooler pipe bracket.
    5. Fig 2: Fluid Cooler Inlet And Outlet Pipes
    GM863264Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the fluid cooler inlet and outlet pipes from the transaxle.
  6. Inspect the transaxle fluid cooler hoses for leaks or fatigue. Replace as necessary.
  7. Inspect the fluid cooler pipes for kinks, leaks or other damage. Replace as necessary.
scientia non olet · About LEMON Manuals