Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Manual Selector Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the manual selector into the vehicle. Secure the manual selector with 4 nuts.
Tighten: Tighten the manual selector bolts to 16 N.m (12 lb ft).

Fig 2: Removing/Installing Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the manual selector electrical connectors.

Fig 3: Removing/Installing Shift Select Cable From/To Shift Lever Plate

Courtesy of GENERAL MOTORS CORP.

Install the shift select cable into the shift lever plate.

Fig 4: Removing/Installing Shift Select Cable From/To Manual Selector Lever

Courtesy of GENERAL MOTORS CORP.

Connect the shift select cable to the manual selector lever.

Fig 5: Park Lock Cable Location

Courtesy of GENERAL MOTORS CORP.

Install the park lock cable to the shift lever plate.

Fig 6: Shifter Assembly Retaining Clip

Courtesy of GENERAL MOTORS CORP.

Connect the park lock cable to the manual selector lever.
Install the center instrument trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Center in Instrument Panel, Gages and Console.
Install the instrument compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
Install the front floor console. Refer to Trim Plate Replacement - Front Floor Console in Instrument Panel, Gages and Console.
Connect the negative battery cable.