LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Automatic Transmission - Mu4 (Introduction, Service & Replacement)) >> Repair Instructions >> Drive Axle Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using J 46007  and. J 42176-10  and. J 42176  , install the new drive axle shaft seal into the transaxle. See Special Tools and Equipment .
  2. Apply J 36850  to the new drive axle shaft seal lip.
  3. Install the drive axle into the vehicle. Refer to Wheel Drive Shaft Replacement - Front in Wheel Drive Shafts.
  4. Install the front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Install the left splash shield on the vehicle, if removed. Refer to Splash Shield Replacement - Engine - Left in Body Front End.
  6. Install the right splash shield on the vehicle, if removed. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
    7. Fig 1: Differential Drain Plug
    GM870108Courtesy of GENERAL MOTORS CORP.
  7. Install the transaxle differential drain plug.

    Tighten:  Tighten the drain plug to 17 N.m (13 lb ft).

  8. Lower the vehicle.
  9. Refill the transaxle, as necessary.
scientia non olet · About LEMON Manuals