LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Automatic Transmission - Mu4 (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Mount Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear transaxle mount into the rear transaxle mounting bracket.
  2. Secure the rear transaxle mount with the through bolt. Do NOT fully tighten the through bolt.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Rear Mount To Transmission Support Bolt And Nuts
    GM865493Courtesy of GENERAL MOTORS CORP.
  4. Install the 3 nuts and 1 bolt to secure the rear transaxle mount to the transmission support.

    Tighten:  Tighten the nuts and bolt to 52 N.m (38 lb ft).

  5. Lower the vehicle.
    6. Fig 2: Rear Mount Through Bolt
    GM865489Courtesy of GENERAL MOTORS CORP.
  6. Tighten the through bolt.

    Tighten:  Tighten the through bolt to 87 N.m (64 lb ft).

  7. Remove the engine support fixture from the engine.
scientia non olet · About LEMON Manuals