LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Automatic Transmission - Mu4 (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Mount Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Remove the positive and the negative battery cable.
  2. Remove the battery hold down bracket bolt and nut.
  3. Remove the battery bracket.
  4. Remove the battery and the battery tray.
  5. Disconnect the IAT connector.
  6. Remove the IAT sensor.
  7. Remove the air cleaner hose and cap assembly.
  8. Remove the air filter.
  9. Remove the 3 air cleaner lower box bolts.
  10. Remove the air cleaner box.
  11. Support the engine with the engine support fixture. Refer to Engine Support Fixture in Engine Mechanical-1.8L (LV6).
  12. Remove the transaxle left mount through bolt.
  13. Remove the 4 bolts and the left transaxle mount.
  14. Remove the 3 left transaxle bracket bolts and bracket.
scientia non olet · About LEMON Manuals