LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Automatic Transmission - Mu4 (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Mount Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the 3 left transaxle bracket and bolts.

    Tighten:  Tighten the transaxle bracket bolts to 80 N.m (59 lb ft).

  2. Install the left transaxle mount and the 4 bolts.

    Tighten:  Tighten the left transaxle mount bolts to 52 N.m (38 lb ft).

  3. Install the transaxle mount through bolt.

    Tighten:  Tighten the transaxle mount through bolt to 80 N.m (59 lb ft).

  4. Remove the engine support fixture.
  5. Install the air cleaner box.
  6. Install the 3 air cleaner box bolts.
  7. Install the air filter.
  8. Install the air cleaner hose and cap assembly.
  9. Install the IAT sensor.
  10. Connect the IAT connector.
  11. Install the battery tray and battery. Refer to Battery Replacement in Engine Electrical.
  12. Install the hold down bracket.
  13. Install the hold down bracket bolt and nut.

    Tighten:  Tighten the hold down bracket bolt and nut to 12 N.m (106 lb in).

  14. Install the positive and negative battery cables.
scientia non olet · About LEMON Manuals