LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Automatic Transmission - Mu4 (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Mount Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine support fixture. Refer to Engine Support Fixture in Engine Mechanical-1.8L (LV6).
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the left hand splash shield. Refer to Splash Shield Replacement - Engine - Left in Body Front End.
  4. Remove the right hand splash shield. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
  5. Remove the 2 bolts from the front transaxle mount.
  6. Remove the front transaxle mount through bolt
  7. Remove the insulator to the mount bracket.
  8. Remove the 2 front transaxle bracket bolts and bracket from the transaxle.
scientia non olet · About LEMON Manuals