LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1327 (Automatic Transmission - Mu4 (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Mount Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the front transaxle bracket and bolts.

    Tighten:  Tighten the transaxle bracket bolts to 64 N.m (47 lb ft).

  2. Install the insulator to the mount bracket.
  3. Install the front transaxle mount through bolt.

    Tighten:  Tighten the transaxle mount through bolt to 52 N.m (38 lb ft).

  4. Install the 2 bolts to the front transaxle mount.

    Tighten:  Tighten the front transaxle mount bolts to 39 N.m (29 lb ft).

  5. Install the left hand splash shield. Refer to Splash Shield Replacement - Engine - Left in Body Front End.
  6. Install the right hand splash shield. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
  7. Lower the vehicle.
  8. Remove the engine support fixture.
scientia non olet · About LEMON Manuals