LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Plate Replacement - Instrument Panel (I/P) Accessory Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Left Trim Plate, Power Mirror Electrical Connector And Dimmer Electrical Connector
    GM843695Courtesy of GENERAL MOTORS CORP.
  1. Install the dimmer switch, if removed. Refer to Instrument Panel (I/P) Dimmer Switch Replacement .
  2. Install the power mirror switch, if removed. Refer to Power Mirror Switch Replacement .
  3. Connect the following components:
    • The dimmer switch electrical connector
    • The power mirror switch electrical connector
  4. Install the IP accessory center trim plate (1) to the IP assembly. Ensure that the retaining clips are fully engaged.
scientia non olet · About LEMON Manuals