LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Plate Replacement - Front Floor Console >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Console Trim Plate, Center A/C Control Knob And Screw
    GM834948Courtesy of GENERAL MOTORS CORP.
  1. Install the accessory power receptacle, if removed. Refer to Accessory Power Receptacle Replacement - 115 Volt AC - Instrument Panel (I/P) in Power Outlets.
  2. Install the cigar lighter assembly, if removed. Refer to Cigar Lighter Housing Replacement - Floor Console in Power Outlets.
  3. Connect the following components:
    • The 2 cigar lighter electrical connectors
    • The accessory power receptacle electrical connectors
  4. Install the front floor console trim plate (2) to the front floor console assembly. Ensure that the retaining clips are fully engaged.
  5. Install the center screw (1).
  6. Install the center A/C control knob (3).
  7. Install the manual transmission shift knob, if equipped.
scientia non olet · About LEMON Manuals