LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Panel Replacement - Instrument Panel (I/P) Center >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Center Trim Plate
    GM835188Courtesy of GENERAL MOTORS CORP.
  1. Using a taped flat bladed tool, gently pry and release the retaining clips which secure the IP accessory center trim plate (1) to the instrument panel assembly.
  2. Disconnect the following components:
    • The A/C switch electrical connector
    • The hazard warning switch electrical connector
    • The rear defogger switch electrical connector
    • The passenger seat belt indicator electrical connector
  3. Remove the A/C switch, if necessary. Refer to HVAC Control Assembly Replacement (Control Assembly) in HVAC Systems - Manual.
  4. Remove the hazard warning switch, if necessary. Refer to Hazard Warning Switch Replacement .
  5. Remove the rear defogger switch, if necessary. Refer to Rear Window Defogger Switch Replacement .
  6. Press the locking tabs and remove the passenger seat belt indicator from the IP center trim panel.
scientia non olet · About LEMON Manuals