LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Panel Replacement - Instrument Panel (I/P) Center >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Center Trim Plate
    GM835188Courtesy of GENERAL MOTORS CORP.
  1. Slide the passenger seat belt indicator into the IP center trim panel until the locking tabs engage.
  2. Install the rear defogger switch, if removed. Refer to Rear Window Defogger Switch Replacement .
  3. Install the hazard warning switch, if removed. Refer to Hazard Warning Switch Replacement .
  4. Install the A/C switch, if removed. Refer to HVAC Control Assembly Replacement (Control Assembly) in HVAC Systems - Manual.
  5. Connect the following components:
    • The passenger seat belt indicator electrical connector
    • The rear defogger switch electrical connector
    • The hazard warning switch electrical connector
    • The A/C switch electrical connector
  6. Install the IP accessory center trim plate (1) to the IP assembly. Ensure that the retaining clips are fully engaged.
scientia non olet · About LEMON Manuals