LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cluster Assembly, Lower Clips And Screw
    GM835522Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The ignition switch must be in the OFF position when removing the instrument cluster assembly.
  1. Remove the IP cluster trim plate. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster .
  2. Remove the screw (1) which secures the instrument cluster assembly (2).
  3. Disengage the 2 lower clips (3).
  4. Disconnect the electrical connector from the cluster assembly (2).
  5. Remove the cluster assembly (2) from the instrument panel assembly.
scientia non olet · About LEMON Manuals