LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel (I/P) Trim Panel Replacement - Lower >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Disable the driver and passenger SIR system. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 in SIR.
  3. Remove the I/P upper trim panel. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper  in Instrument Panel, Gages, and Console.
  4. Remove the steering column. Refer to Steering Column Replacement in Steering Wheel and Column.
  5. Remove the body hinge pillar trim panels. Refer to Trim Replacement - Hinge Pillar in Interior Trim.
  6. Remove the sill plates. Refer to Door Sill Plate Replacement in Interior Trim.
  7. Remove the front floor console. Refer to Console Replacement - Front Floor  in Instrument Panel, Gages, and Console.
  8. Remove glove compartment. Refer to Compartment Replacement - Instrument Panel (I/P)  in Instrument Panel, Gages, and Console.
  9. Remove the HVAC control assembly. Refer to HVAC Control Assembly Replacement (Control Assembly) in HVAC Systems-Manual.
  10. Remove manual selector. Refer to Manual Selector Replacement in Automatic Transmission (MU4).
  11. Disengage the hood release cable from hood release handle. Refer to Hood Latch Release Handle Replacement in Body Front End.
    12. Fig 1: Lower Instrument Panel Components
    GM844251Courtesy of GENERAL MOTORS CORP.
  12. Remove the following components from the lower instrument panel:
    • The 8 bolts
    • The 4 push retainers
    • The wire harness clamps
  13. Remove the lower instrument panel by pulling rearward.
scientia non olet · About LEMON Manuals