LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel (I/P) Carrier Support Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Center Support Bracket Components
    GM844460Courtesy of GENERAL MOTORS CORP.
  1. Remove the upper I/P panel. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper .
  2. Remove the lower I/P panel. Refer to Instrument Panel (I/P) Trim Panel Replacement - Lower .
  3. Disengage the wire harness clamps.
  4. Remove the instrument panel pad lower bolts (12).
  5. Remove the instrument panel pad lower (11).
  6. Remove ground cable.
  7. Remove the I/P center support braces (6, 9). Refer to Bracket Replacement - Instrument Panel (I/P) Center Support .
  8. Remove the windshield defroster nozzle duct from the heater case assembly.
  9. Remove the following retainers from the instrument panel reinforcement at the hinge pillars:
    • The 7 bolts
    • The 1 nut
  10. Route out harness and remove the instrument panel reinforcement (4) from the vehicle.
scientia non olet · About LEMON Manuals