LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Console Replacement - Rear Floor >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Console Components
    GM844613Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector (4).
  2. Install the front floor rear console (3) to the vehicle.
  3. Lower the parking brake lever.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the front 2 bolts (5) to the front compartment of the rear console and the 2 rear bolts (2) to the rear of the console (3)..

    Tighten:  Tighten the console bolts to 15 N.m (11 lb in).

  5. Install the front insert (6) to the rear console (3).
  6. Install the console box damper (1) to the rear compartment of the rear console (3).
scientia non olet · About LEMON Manuals