LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Bracket Replacement - Instrument Panel (I/P) Center Support >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Center Support Bracket Components
    GM844460Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the left I/P center support brace (9) and the right I/P center support brace (6) to the vehicle. Secure the braces with the following retainers:
    • The left brace nut (10)
    • The right brace nut (5)
    • The right brace bolt (7)
    • The left brace bolt (8)

      Tighten:  Tighten the I/P center support brace nuts and bolts to 20 N.m (15 lb ft).

  2. Install the connector housing bracket to the right I/P center support brace.
  3. Install the lower instrument panel assembly. Refer to Instrument Panel (I/P) Trim Panel Replacement - Lower .
  4. Install the upper instrument panel assembly. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper .
scientia non olet · About LEMON Manuals