Enabling Zone 9
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the yellow 2-way connectors to the driver and passenger seat modules (1).
- Connect the connectors and lock the connectors with the connector lock levers.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
- Install the AM2 Fuse into the junction block (1).
- Use caution while reaching in and turn the ignition switch to the ON position.
- The AIR BAG indicator will flash then turn OFF.
- Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - SIR .