LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1323 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Brace Replacement (LNK) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Cover, Generator Brace, Nuts And Bolts
    GM840474Courtesy of GENERAL MOTORS CORP.
  1. Install the generator brace (4) to the vehicle. Secure the brace with the two bolts (6).

    Tighten:  Tighten the two bolts (6) to 29 N.m (21 lb ft).

  2. Install the engine cover (1). Secure the cover with the three bolts (3) and one nut (2).

    Tighten:  Tighten the three bolts (3) and one nut (2) to 7 N.m (62 lb in).

scientia non olet · About LEMON Manuals