LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1323 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> Charge Indicator Always On

Charge Indicator Always On

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Charge Indicator Always On

Step Action Values Yes No
Schematic Reference: Starting and Charging Schematics 
Connector End View Reference: Engine Electrical Connector End Views 
1 Did you review the following description and operations and perform the necessary inspections? - Go to Step 2  Go to Symptoms - Engine Electrical 
2 Start the engine.
Does the charge indicator remain illuminated?
- Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3
  1. Leave the engine running.
  2. Turn on the headlamps.
  3. Measure the voltage at the battery terminals.
Is the voltage within the specified value?
12.5-15.5 V Go to Step 4  Go to Charging System Test 
4
  1. Turn OFF the ignition.
  2. Disconnect the generator harness connector.
  3. Start the engine.
Does the charge indicator remain illuminated?
- Go to Step 7  Go to Step 5 
5
  1. Turn OFF the ignition.
  2. Disconnect the generator harness connector.
  3. Turn the ignition switch to the ON position.
  4. Measure the voltage between the sense circuit of the generator and ground.
Is the voltage measured near the specified value?
B+ Go to Step 6  Go to Step 8 
6 Inspect for poor connection at the generator. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 10  Go to Step 9 
7 Repair the short to ground in the charge indicator circuit. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?
- Go to Step 10  -
8 Repair the high resistance or open in the sense circuit of the generator. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?
- Go to Step 10  -
9 Replace the generator. Refer to Generator Replacement .
Did you complete the repair?
- Go to Step 10  -
10 Operate the system in order to verify the repair.
Did you correct the condition?
- System OK Go to Step 3