LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1322 (Lighting Systems) >> Repair Instructions >> Tail Lamp Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Tail Lamp Components
    GM819965Courtesy of GENERAL MOTORS CORP.
  1. Open the rear compartment lid.
  2. Remove the rear compartment trim panel (4).
  3. Disconnect the tail lamp electrical connectors.
  4. Remove the following components from the vehicle:
    • The 3 nuts (3)
    • The tail lamp (7)
  5. Remove the following from the tail lamp:
    • The stop lamp socket (2)
    • The turn signal lamp socket (5)
  6. Remove the following from the lamp sockets, if necessary:
    • The stop lamp bulb (1)
    • The turn signal lamp bulb (6)
scientia non olet · About LEMON Manuals