LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1322 (Lighting Systems) >> Repair Instructions >> License Lamp Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open liftgate.
  2. Remove trim panel service hole cover. Refer to Trim Panel Replacement - Liftgate .
    3. Fig 1: License Plate Lamp And Liftgate
    GM824519Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the license lamp electrical connector.
  4. Remove the license plate lamp bulb, turning counterclockwise.
  5. Squeeze the tabs on each side of the license plate lamp (1).
  6. Remove the license plate lamp (1) from the liftgate (2).
scientia non olet · About LEMON Manuals