Clutch Rotor and/or Bearing Removal (V5 - Direct Mount)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 41790 Compressor Holding Fixture
J 41552 Compressor Pulley Puller
J 33023-A Puller Pilot

Install the compressor onto the J 41790 .

Fig 1: Compressor & J 41790
Courtesy of GENERAL MOTORS CORP.
Remove the clutch plate and hub assembly (2).
Remove the clutch rotor and bearing assembly retaining ring (3), using external snap ring pliers (1).

Fig 2: Clutch Plate, Hub Assembly, Clutch Rotor & Bearing Assembly Retaining Ring
Courtesy of GENERAL MOTORS CORP.
Place the J 33023-A on the clutch rotor.

Fig 3: Clutch Rotor, J 33023-A & J 41790
Courtesy of GENERAL MOTORS CORP.
Install the J 41552 down into the inner circle of slots in the rotor.
Turn the compressor pulley puller clockwise in the slots to engage the puller tangs with the rotor.
Hold the compressor pulley puller in place and use a wrench to turn the center forcing screw against the puller pilot to remove the clutch rotor and bearing assembly.

Fig 4: Clutch Rotor, J 41552 & J 41790
Courtesy of GENERAL MOTORS CORP.