LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Transfer Case - NVG 246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Speed Sensor Replacement (Left Rear) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transfer Case Left Rear Speed Sensor
    GM648202Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the transfer case left rear speed sensor into the transfer case.

    Tighten:  Tighten the transfer case left rear speed sensor to 15 N.m (11 lb ft).

  2. Install the transfer case left rear speed sensor electrical connector.
  3. Lower the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
scientia non olet · About LEMON Manuals