LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Transfer Case - NVG 246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Speed Sensor Replacement (Front) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vehicle Speed Sensor
    GM662047Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the transfer case front speed sensor into the transfer case.

    Tighten:  Tighten the transfer case front speed sensor to 15 N.m (11 lb ft).

    2. Fig 2: Transfer Case Front Speed Sensor Electrical Connector
    GM651506Courtesy of GENERAL MOTORS CORP.
  2. Install the transfer case front speed sensor electrical connector.
  3. Install the transfer case shield. Refer to Transfer Case Shield Replacement .
  4. Lower the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
scientia non olet · About LEMON Manuals