LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Transfer Case - NVG 246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transfer Case Shield
    GM396828Courtesy of GENERAL MOTORS CORP.
  1. Install the transfer case shield to the transmission support.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transfer case shield mounting bolts.

    Tighten:  Tighten the transfer case shield mounting bolts to 20 N.m (15 lb ft).

  3. Lower the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
scientia non olet · About LEMON Manuals