LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Transfer Case - NVG 246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: J 43484 & J 8092
    GM678236Courtesy of GENERAL MOTORS CORP.
  1. Install the J 43484  (2) to the J 8092  (1).
  2. Install the transfer case front input shaft seal on the J 43484  .
  3. Using the J 43484  (2) and the J 8092  (1), install the transfer case output seal.
  4. Install the front propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - ONE PIECE .
  5. Check the transfer case fluid level. Refer to Transfer Case Fluid Replacement .
  6. Install the transfer case shield. Refer to Transfer Case Shield Replacement .
  7. Lower the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
scientia non olet · About LEMON Manuals