LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Transfer Case - NVG 246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Motor/Encoder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Motor/Encoder Electrical Connectors
    GM715660Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the transfer case shield. Refer to Transfer Case Shield Replacement .
  3. Remove the front propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - ONE PIECE .
  4. Remove the motor/encoder electrical connectors.
    5. Fig 2: Motor/Encoder Mounting Bolts
    GM662850Courtesy of GENERAL MOTORS CORP.
  5. Remove the motor/encoder mounting bolts.
  6. Remove the motor/encoder assembly.
  7. Remove the motor/encoder gasket.
scientia non olet · About LEMON Manuals