LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Transfer Case - NVG 246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Fluid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transfer Case Drain Plug
    GM660282Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: If the drain or fill plug have to be replaced, used only aluminum replacement drain plugs. Steel plugs will react with the magnesium of the transfer case.
  1. Install the transfer case drain plug.

    Tighten:  Tighten the transfer case drain plug to 20 N.m (15 lb ft).

  2. Fill the transfer case to the bottom of the fill hole with the approved fluid.
    3. Fig 2: View Of Transfer Case Fill Plug
    GM660281Courtesy of GENERAL MOTORS CORP.
  3. Install the transfer case fill plug.

    Tighten:  Tighten the transfer case fill plug to 20 N.m (15 lb ft).

  4. Install the transfer case shield. Refer to Transfer Case Shield Replacement .
  5. Lower the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
scientia non olet · About LEMON Manuals