LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Transfer Case - NVG 246-NP8 (Two Speed Automatic)) >> Diagnostic Information and Procedures >> Diagnostic System Check - Transfer Case >> Test Description

Test Description

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
  2. 3:  The presence of DTCs indicates that the transfer case shift control module has detected a fault. Go to symptoms for other concerns.
  3. 4:  The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
  4. 5:  Vehicle speed is provided to the transfer case shift control module via Class 2 and can effect the setting of DTC C0300. Perform the diagnostics for powertrain DTCs P0502 and P0503 first.
  5. 6:  Perform diagnostics for DTC C0300 and C0305 first before addressing other DTCs. DTC C0300 and C0305 can be responsible for setting other DTCs.
Transfer Case Diagnostic System Check

Step Action Yes No
1 Install a scan tool.
Does the scan tool power up?		 Go to Step 2  Go to SCAN TOOL DOES NOT POWER UP
2 
  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the transfer case shift control module.
Does the scan tool communicate with the transfer case shift control module?		 Go to Step 3  Go to SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE
3  Select the transfer case shift control module display DTCs function on the scan tool.
Does the scan tool display any DTCs?		 Go to Step 4  Go to Symptoms - Transfer Case 
4  Does the scan tool display any DTCs which begin with a "U"? Go to SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 DEVICE Go to Step 5 
5  Does the scan tool display DTC P0502 or P0503? Go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS 4.8L, 5.3L and 6.0L in Engine Controls Go to Step 6 
6  Does the scan tool display DTC C0300 or C0305? Go to DTC C0300  or DTC C0305  Go to Diagnostic Trouble Code (DTC) List 
scientia non olet · About LEMON Manuals