LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1314 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Lift Gate Window >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate window.
  2. Remove the lift gate window struts. Refer to STRUT REPLACEMENT - LIFT GATE WINDOW  .
  3. Starting at the corner of the liftgate flange, pull the weather-strip molding from the liftgate.
    Fig 1: Pulling Weather - Strip Molding From Liftgate
    G01435048Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals