LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1309 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the windshield wiper arms. Refer to WIPER ARM REPLACEMENT in Wipers/Washer System.
  2. Remove the following components from the vehicle:
    • The 2 plastic retainers (1)
    • The air inlet grille panels (2)
  3. Remove the rear hood seal from the air inlet grille panel, if necessary. Refer to SEAL REPLACEMENT - HOOD REAR   .
    Fig 1: Removing Air Inlet Grille Panels & Plastic Retainers
    G01434569Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals