LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1309 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear hood seal to the air inlet grille panel, if removed. Refer to SEAL REPLACEMENT - HOOD REAR  .
  2. Install the air inlet grille panels (2) to the vehicle.
  3. Install the 2 plastic retainers (1).
  4. Install the windshield wiper arms. Refer to WIPER ARM REPLACEMENT in Wipers/Washer System.
    Fig 1: Installing Air Inlet Grille Panels & Plastic Retainers
    G01434570Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals