LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Exterior Trim) >> Repair Instructions >> Molding/Nameplate Replacement - Exterior Trim >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. The following components are attached to the body panels with adhesive tape:
    • The moldings
    • The rear compartment lid emblem
    • The name plates
  2. Apply masking tape (1) to the body side border of the emblem, the nameplate or the molding to protect the body from scratches. The tape will also aid in aligning the moldings during installation.

    Important:  Do not overheat the component.

  3. Using an auxiliary heat source, heat the molding, the emblem or the nameplate to between 40-60 °C (104-140° F).
  4. Use J 41409  or the equivalent in order to cut through the adhesive material.
  5. Remove the molding (2), the emblem or the nameplate from the vehicle.
    Fig 1: Removing Molding Emblem Or Nameplate From Vehicle
    G01434280Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals