LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1306 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new plastic clips to the rocker panel molding.
  2. Line up the rocker panel molding to the plastic clip holes on the rocker panel and push firmly until the rocker panel molding snaps in.
  3. Install the rocker panel molding push in retainers to the under side of the rocker panel molding.
    Fig 1: Installing Rocker Panel Molding
    G01434298Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals