Molding Repair
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use of harsh chemicals when cleaning can damage exterior lamps. Suggested cleaners are a mild soap and water, or Varnish Makers and Painters (VM&P) Naptha. VM&P Naptha is a specific type of naptha and should not be substituted by any other naptha.
- Wash the affected area with soap and water.
- Wipe the area dry.
- Wipe the panel and the adhesive side of the molding with a clean rag using oil-free naphtha or alcohol.
- Do NOT remove the tape from the body if the molding has pulled loose from the adhesive backing.
- Clean the back of the molding and the tape on the body using oil-free naphtha or alcohol.
- Apply masking tape (1) or use a straightedge as a molding guide in order to ensure that the molding is straight.
- Apply Goodwrench trim body adhesive GM P/N 12345632 (Canadian P/N 10953475) or equivalent to the back of the molding.
- Press the molding into place.
- Apply constant pressure to the molding for 30 seconds or until a firm bond is made.