LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1303 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Multifunction Alarm Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the negative battery cable.

    Important:  The multifunction alarm module is located under the instrument panel on the drivers side.

  2. Remove the screws from the junction block and position the junction block in order to gain access to the multifunction alarm module.
  3. Disconnect the multifunction alarm module electrical connector.
  4. Disconnect the multifunction alarm module (1) from the rear of the junction block (2).
    Fig 1: Disconnecting Multifunction Alarm Module From Rear Of Junction Block
    G01433985Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals