LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1303 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Multifunction Alarm Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the multifunction alarm module (1) to the rear of the junction block (2).
  2. Connect the multifunction alarm module electrical connector.
  3. Reposition the junction block back into position. Secure the junction block with the screws.
  4. Connect the negative battery cable.
    Fig 1: Connecting Multifunction Alarm Module To Rear Of Junction Block
    G01433986Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals