LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1300 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wiper motor assembly (3) to the cowl.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the wiper motor transmission. Refer to WIPER TRANSMISSION REPLACEMENT  in Wipers and Washers.
  3. Install the 2 wiper motor assembly bolts (2).

    Tighten 

  4. Tighten the bolts to 5.5 N.m (48 lb in).
  5. Connect the wiper motor electrical connector (1).
  6. Install the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT in Body Front End.
  7. Install the wiper arms. Refer to WIPER ARM REPLACEMENT  in Wipers and Washers.
    Fig 1: Installing Wiper Motor Assembly
    G01433855Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals