LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1300 (Wiper System & Washer System) >> Repair Instructions >> Washer Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front or rear washer pump (3) to the washer solvent container (2) pressing in until fully seated.
  2. Connect the front or rear washer hose (4) to the front or rear washer pump (3).
  3. Connect the front or rear washer pump electrical connector (1).
  4. Fill the washer solvent container (2) with washer solvent.
  5. Refasten the right front lower wheel house panel. Refer to WHEELHOUSE PANEL REPLACEMENT in Body Front End.
    Fig 1: Installing Washer Pump
    G01433833Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals