LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Steering Wheel And Steering Column) >> Removal & Installation >> Steering Column >> Removal

Steering Column: Removal

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable SIR system (if equipped). See DISABLING & ACTIVATING AIR BAG SYSTEM . Disconnect negative battery cable. Set front wheels in straight-ahead position and turn ignition switch to LOCK position. Remove trim panels from around steering column as necessary.
  2. Remove steering wheel. See STEERING WHEEL . Remove stoplight switch. On most models, remove lower column joint coupling bolt attaching steering rack intermediate shaft to steering column shaft. If required, remove lower column toe plate-to-firewall attaching bolts.
  3. On column shift models, disconnect transmission linkage rod or cable from lever on shift tube and disconnect gear indicator cable from column. On floor shift models, disconnect park lock cable from ignition lock inhibitor. Disconnect electrical connectors as necessary. Remove steering column bracket(s) mounting nuts, and remove steering column.
scientia non olet · About LEMON Manuals