Removal & Installation
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
Remove turn signal switch. See TURN SIGNAL SWITCH . With ignition key removed, remove buzzer switch. Insert key into lock cylinder. On all except "C" body, turn lock cylinder to LOCK position. Remove lock cylinder retaining screw.
On "H" body, remove pivot and pulse switch connector from bulkhead connector and remove 13-way secondary lock. Remove pass key wire terminals No. 12 and 13.
On "C" body, remove lower and upper column shroud. Turn key to START position. Push lock cylinder lock pin using 1/16" Allen wrench. Release key to RUN position.
On all bodies, remove lock cylinder. To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .